Diagnostics and troubleshooting Deltabar PMD75B HART
60 Endress+Hauser
11.3 Diagnostic event in the operating tool
If a diagnostic event is present in the device, the status signal appears in the top left status
area of the operating tool along with the corresponding symbol for the event level in
accordance with NAMUR NE 107:
• Failure (F)
• Function check (C)
• Out of specification (S)
• Maintenance required (M)
Click the status signal to see the detailed status signal.
The diagnostic events and remedial measures can be printed out as a Diagnostic list
submenu.
11.4 Adapting the diagnostic information
The event level can be configured:
Menu path: Diagnostics → Diagnostic settings → Configuration
11.5 Pending diagnostic messages
The display alternates between the queued diagnostic messages and the measured value.
Queued diagnostic messages can also be displayed in the Actual diagnostics parameter.
Menu path: Diagnostics → Actual diagnostics
11.6 Diagnostic list
In the Diagnostic list submenu, currently pending diagnostic messages can be displayed. If
several messages are pending, the messages with the highest priority are shown on the
display.
Navigation path
Diagnostics → Diagnostic list
To Next Page
Loading...
Need help?
General
