Endress+Hauser Hart Proline Promag P 500 - Configuration Management

Commissioning Proline Promag P 500 HART
126 Endress+Hauser
Parameter Prerequisite Description User entry /
Selection
Factory setting
WLAN passphrase The WPA2-PSK option is
selected in the Security type
parameter.
Enter the network key (8 to 32
characters).

The network key
supplied with the device
should be changed
during commissioning
for security reasons.
8 to 32-digit
character string
comprising numbers,
letters and special
characters
Serial number of the
measuring device
(e.g. L100A802000)
Assign SSID name – Select which name will be used
for SSID: device tag or user-
defined name.
• Device tag
• User-defined
User-defined
SSID name • The User-defined option is
selected in the Assign SSID
name parameter.
• The WLAN access point
option is selected in the
WLAN mode parameter.
Enter the user-defined SSID
name (max. 32 characters).

The user-defined SSID
name may only be
assigned once. If the SSID
name is assigned more
than once, the devices
can interfere with one
another.
Max. 32-digit
character string
comprising numbers,
letters and special
characters
EH_device
designation_last 7
digits of the serial
number (e.g.
EH_Promag_500_A
802000)
Apply changes – Use changed WLAN settings. • Cancel
• Ok
Cancel
10.5.7 Configuration management
After commissioning, you can save the current device configurationor restore the previous
device configuration.
You can do so using the Configuration management parameter and the related options
found in the Configuration backup submenu.
Navigation
"Setup" menu → Advanced setup → Configuration backup
‣
Configuration backup
Operating time
→  126
Last backup
→  126
Configuration management
→  127
Backup state
→  127
Comparison result
→  127
Parameter overview with brief description
Parameter Description User interface / Selection Factory setting
Operating time Indicates how long the device has been in
operation.
Days (d), hours (h), minutes
(m) and seconds (s)
–
Last backup Shows when the last data backup was saved
to HistoROM backup.
Days (d), hours (h), minutes
(m) and seconds (s)
–