Endress+Hauser Hart Proline Promag P 500 - Measuring Device Configuration; Defining the Tag Name; Setting the System Units

Commissioning Proline Promag P 500 HART
96 Endress+Hauser
10.4.1 Defining the tag name
To enable fast identification of the measuring point within the system, you can enter a
unique designation using the Device tag parameter and thus change the factory setting.
1
XXXXXXXXX
A0029422
 44 Header of the operational display with tag name
1 Tag name
Enter the tag name in the "FieldCare" operating tool →  88
Navigation
"Setup" menu → Device tag
Parameter overview with brief description
Parameter Description User entry Factory setting
Device tag Enter the name for the measuring point. Max. 32 characters, such as
letters, numbers or special
characters (e.g. @, %, /).
Promag
10.4.2 Setting the system units
In the System units submenu the units of all the measured values can be set.
Depending on the device version, not all submenus and parameters are available in
every device. The selection can vary depending on the order code.
Navigation
"Setup" menu → System units
‣
System units
Volume flow unit
→  97
Volume unit
→  97
Conductivity unit
→  97
Temperature unit
→  97
Mass flow unit
→  97
Mass unit
→  97
Density unit
→  97