Endress+Hauser Hart Proline Promag P 500 - Page 49

Proline Promag P 500 HART Electrical connection
Endress+Hauser 49
L
WARNING
Housing degree of protection may be voided due to insufficient sealing of the housing.
‣
Screw in the screw without using any lubricant.
L
WARNING
Excessive tightening torque applied to the fixing screws!
Risk of damaging the plastic transmitter.
‣
Tighten the fixing screws as per the tightening torque: 2 Nm (1.5 lbf ft)
11. Tighten the 4 fixing screws on the housing cover.
Removing a cable
3 (0.12)
2.
1.
A0029598
 17 Engineering unit mm (in)
1. To remove a cable from the terminal, use a flat-blade screwdriver to push the slot
between the two terminal holes
2. while simultaneously pulling the cable end out of the terminal.