Endress+Hauser Liquiline CM44P - Page 151

Liquiline CM44P Diagnostics and troubleshooting
Endress+Hauser 151
No. Message Factory settings Sensor
type
Tests or remedial action
S
1)
D
2)
F
3)
189 Operating time M On Off O Operating hours > 5 °C, measurement can
still take place
1. Replace sensor.
2. Change monitoring limit.
3. Disable monitoring.
190 Operating time M On Off O Operating hours > 25 °C, measurement
can still take place
1. Replace sensor.
2. Change monitoring limit.
3. Disable monitoring.
191 Operating time M On Off O, I, DI Operating hours > 30 °C, measurement
can still take place
1. Replace sensor.
2. Change monitoring limit.
3. Disable monitoring.
192 Operating time M On Off O, I Operating hours > 40 °C, measurement
can still take place
1. Replace sensor.
2. Change monitoring limit.
3. Disable monitoring.
193 Operating time M On Off P, C, O Operating hours > 80 °C, measurement
can still take place
1. Replace sensor.
2. Change monitoring limit.
3. Disable monitoring.
194 Operating time M On Off P Operating hours > 100 °C, measurement
can still take place
1. Replace sensor.
2. Change monitoring limit.
3. Disable monitoring.
195 Operating time M On Off C Operating hours > 120 °C, measurement
can still take place
1. Replace sensor.
2. Change monitoring limit.
3. Disable monitoring.
196 Operating time M On Off C Operating hours > 125 °C, measurement
can still take place
1. Replace sensor.
2. Change monitoring limit.
3. Disable monitoring.
197 Operating time M On Off C Operating hours > 140 °C, measurement
can still take place
1. Replace sensor.
2. Change monitoring limit.
3. Disable monitoring.