Endress+Hauser Liquiline CM44P - Basic safety instructions; 2.2 Designated use

Liquiline CM44P Basic safety instructions
Endress+Hauser 7
2 Basic safety instructions
2.1 Requirements for personnel
• Installation, commissioning, operation and maintenance of the measuring system may
be carried out only by specially trained technical personnel.
• The technical personnel must be authorized by the plant operator to carry out the
specified activities.
• The electrical connection may be performed only by an electrical technician.
• The technical personnel must have read and understood these Operating Instructions
and must follow the instructions contained therein.
• Faults at the measuring point may only be rectified by authorized and specially trained
personnel.
Repairs not described in the Operating Instructions provided must be carried out only
directly at the manufacturer's site or by the service organization.
2.2 Designated use
2.2.1 Non-hazardous atmosphere
Liquiline CM44P is a multichannel controller for connecting analog photometers and
digital sensors with Memosens technology in non-hazardous environments.
The device is designed for use in the following applications:
• Food and beverages
• Life science
• Power stations
• Chemical industry
• Other industrial applications
2.2.2 Hazardous environment in accordance with cCSAus Class I Div.
2
‣
Please pay attention to the control drawing and specified operating conditions in the
appendix of this manual and follow the instructions.
2.2.3 Non-designated use and improper use
NOTICE
Objects stored on top of the housing
May cause short-circuits or fire or result in the failure of individual cabinet components or
complete failure of the measuring point!
‣
Never place any objects, such as tools, cables, paper, food, liquid containers or similar,
on top of the housing.
‣
Always observe the operator's regulations, in particular with regard to fire safety
(smoking) and foodstuffs (beverages).
Use of the device for any purpose other than that described, poses a threat to the safety of
people and of the entire measuring system and is therefore not permitted.
The manufacturer is not liable for damage caused by improper or non-designated use.