Endress+Hauser Liquiline CM44P - Mounting the Measuring Device (Cabinet Device)

Installation Liquiline CM44P
26 Endress+Hauser
5.3 Mounting the measuring device (cabinet device)
5.3.1 DIN rail mounting
The mounting procedure is the same for all Liquiline devices. The example shows a
CM448R.
1. In the order configuration, the securing clips are "tightened" to secure the DIN rail.
Release the securing clips by pulling them downwards.

2. Attach the device from the top to the DIN rail (a) and secure it by pressing down (b).

a
b
3. Slide the securing clips upwards until they click, thereby securing the device to the
DIN rail.

4. Mount the external power unit in the same way.
5.3.2 Wall mounting
Mounting material (screws, dowels) are not included in the scope of delivery and must
be provided by the customer.
The external power unit can be mounted on a DIN rail only.
Use the back of the housing to mark the mounting holes.
1. Drill the corresponding holes and insert wall plugs if necessary.
2. Screw the housing onto the wall.