Endress+Hauser Liquiline CM44P - Page 27

Liquiline CM44P Installation
Endress+Hauser 27
5.3.3 Mounting the optional external display
L
CAUTION
Sharp-edged, non-deburred drill holes
Risk of injury, display cable may get damaged!
‣
In particular, deburr the central drill hole for the display cable.
Mounting the display on the door of the cabinet
1. Hold the mounting plate from the outside against the door of the control cabinet.
Choose the point at which you wish to install the display.
2. Make all the markings.
.
.
.
. .
.
.
.
..
.
.
.
.
.
. .
.
.
.
..
.
.
4 x Ø 8 (0.31)
Ø 20 (0.79)
3. Draw lines to interconnect all the marks.
 This will indicate the position of the five drill holes needed.
4. Drill the holes (→  13,  21).