Liquiline CM44P Commissioning
Endress+Hauser 61
Menu/Operation/User definable screens
Function Options Info
Actuator type
Source of data is a
controller
Selection
• None
• Bipolar
• Unipolar-
• Unipolar+
Factory setting
None
For more information on controllers and
manipulated variables: → 88.
Label Customized text, 20
characters
User-defined name for the parameter to be
displayed
Set label to "%0V"
1)
Action If you perform this action you accept the
parameter name that is automatically suggested.
Your own parameter name (Label) is lost!
1) "%0V" here stands for text that depends on the context. This text is generated automatically by the
software and inserted in place of %0V. In the simplest situations, the generated text could be the name of
the measuring channel, for example.
9.4 Basic setup
Making basic settings
1. Switch to the Setup/Basic setup menu.
Make the following settings.
2. Device tag: Give your device any name of your choice (max. 32 characters).
3. Set date: Correct the set date if necessary.
4. Set time: Correct the set time if necessary.
For quick commissioning, you can ignore the additional settings for outputs,
relays etc. You can make these settings later in the specific menus.
5. To return to the measuring mode: press the soft key for ESC for at least one second.
Your controller now works with your basic settings. The sensors connected use
the factory settings of the sensor type in question and the individual calibration
settings that were last saved.
If you wish to configure your most important input and output parameters in the Basic
setup :
‣
Configure the current outputs, relays, limit switches, controllers, device diagnostics and
cleaning cycles with the submenus which follow the time setting.
To Next Page
Loading...
