Endress+Hauser Micropilot FMR62 - Turning the Transmitter Housing; Turning the Display

Micropilot FMR62
Endress+Hauser 37
If process temperatures are high, the device should be included in the usual container insulation
system (2) to prevent the electronics from heating as a result of thermal radiation or convection. The
insulation should not be higher than the neck of the device (1).
Turning the transmitter
housing
To provide easier access to the connection compartment or display module, the transmitter housing
can be turned:
max. 350°
8 mm
8 mm
1.
2.
3.
A0032242
1. Unscrew the securing screw using an open-ended wrench.
2. Rotate the housing in the desired direction.
3. Tighten the securing screw (1.5 Nm for plastic housing; 2.5 Nm for aluminum or stainless steel
housing).
Turning the display Opening the cover
2.
1.
3 mm
A0021430
1. Loosen the screw of the securing clamp of the electronics compartment cover using an Allen
key (3 mm) and turn the clamp 90 ° counterclockwise.
2. Unscrew the cover and check the cover seal, replace it if necessary.
Turning the display module
1.
2.
A0036401