Operating Instructions OXY5500 Gas Analyzer
20 Endress+Hauser
Figure 12. Main menu screen
The OXY5500 display is divided into three sections: status bar, main screen, and navigation bar.
The status bar shows:
• Time: The OXY5500 has a 24-hour clock setting.
The OXY5500 must be calibrated before use. Refer to Performing a two-point calibration → .
If the power to the analyzer is disabled, the Time and Date will be set to 0 on start-up. A warning message will
display in the Status bar as shown in Figure 13.
Figure 13. Warning: Timestamp reset
Reset the Time and Date settings as shown in the Device Settings Menu → before starting a new measurement so
that the correct time is stored in the data.
• The Monitor symbol in the Status bar indicates that logging is activated.
• The Monitor (X) symbol in the Status bar indicates that logging is not activated.
The Main screen consists of the central area of the display above the Navigation Bar and provides information about
the analyzer.
The Navigation Bar is across the lower section of the display and shows the Control buttons used to perform actions
in the analyzer.
• Click Menu to access the MAIN MENU screen.
Refer to Figure 14 for a view of the MENU MAP that outlines the OXY5500 software structure. This section gin with
a review of the top level menu screens (shown in grey boxes in the Menu Map) and then continue with an overview
of the accessible screens available from each menu screen.
Status Bar
Navigation Bar
To Next Page
Loading...
