OXY5500 Gas Analyzer Operating Instructions
Endress+Hauser 23
5.4.1 To enter editing mode
1. Click OK to enter editing mode.
2. Change the setting or value (one digit at a time) by clicking the Arrow buttons.
3. Click OK again to save the changes.
5.4.2 To exit editing mode
1. Click Menu to cancel and exit.
Refer to Measurement Settings (Meas. Settings) Menu Options → for more information on setting temperature
compensation, pressure compensation, interval or logging, and data management.
5.5 Device settings menu
Select Device Settings from the MAIN MENU screen to display the analyzer settings. Refer to Figure 19.
Figure 19. Main menu screen - Device settings selected
The DEVICE SETTINGS menu is divided into three screens: DEVICE SETTINGS, SENSOR DETAILS, and ABOUT. Refer
to Device Settings Menu Options → for more information on setting these options.
Use the Arrow buttons to switch between screens.
5.6 Sensor menu
Select Sensor from the MAIN MENU. Refer to Figure 20. This selection opens the SENSOR OPTIONS window.
Figure 20. Main Menu - Sensor selected
In the SENSOR OPTIONS window, the user can click the Change Parameters button for the connected sensor, the
Calibration button to perform a sensor calibration, or the Relative Accuracy Test Audit (RATA) button. Refer to
Figure 21.
To Next Page
Loading...
