OXY5500 Gas Analyzer Operating Instructions
Endress+Hauser 37
5.12 Sensor menu options
The option to change parameters, sensor type, or to calibrate the analyzer are accessed via the Sensor button on the
MAIN MENU.
5.12.1 Change parameters
Clicking the Change Parameters button in the SENSOR menu causes a message window to display with the question
to abort the currently running measurement. Refer to Figure 43.
Figure 43. Message window - Stop measurements during configurations
Select Yes to stop the measurement in order to display the SENSOR TYPE AND SENSOR CONSTANTS window. Refer
to Figure 44.
Figure 44. Sensor type and sensor constants - Sensor type menu selected for editing
Use the Arrow buttons to navigate between input fields.
5.12.2 To enter editing mode
1. Click OK to edit the highlighted field.
2. Change the setting or value (one digit at a time) by pressing the Up and Down Arrow buttons.
3. Make the desired change to an input field.
4. Click OK again to save the changes.
5.12.3 To exit editing mode
1. Click Menu to cancel and exit.
To Next Page
Loading...
