Operating Instructions OXY5500 Gas Analyzer
38 Endress+Hauser
5.12.4 Changing the sensor type
If it is necessary to change the probe type in the field, change the sensor type (OP-3, OP-6, or OP-9) according to the
sensor that is connected to the analyzer. The displayed sensor constants (dKSV1, dKSV2, dPhi1, dPhi2, f1, and m)
will change according to the sensor type selected.
The sensor constant values can also be located on the Calibration Certificate delivered with the optical oxygen
sensor. Refer to the example in Figure 45.
Figure 45. Calibration certificate example: Calibration data and sensor constants
To Next Page
Loading...
