Endress+Hauser OXY5500 - Page 29

OXY5500 Gas Analyzer Operating Instructions
Endress+Hauser 29
5.9.4 Graph screen
The oxygen values of the current measurement session are displayed in a graph; the last measurement value of the
Current Measurement is shown at the top of the screen. Refer to Figure 30.
Figure 30. Graph screen
In the lower right area of the screen, the number of measurement points of the total number of measurement points
are displayed in the graph. In the lower left of the screen, a progress bar shows the progress of the data being
analyzed.
 When large measurement files are being opened, a pop-up window will display stating, “You are about to open a
very large file.” and requesting confirmation before proceeding. Select No to return to the currently selected
measurement graph or Yes to show the last 248 measurement points of the currently selected measurement file.
When logging is not activated, only the currently measured oxygen values are displayed, starting at the time the
GRAPH screen is opened.
1. Click the Up and Down Arrows to open the Y-Axis Setup window where the minimum and maximum values for
the Y-Axis are set.
2. Select Autoscale or Manual setting of the maximum or minimum values displayed on the Y-Axis. Refer to Figure
31. Autoscale will automatically set the maximum and minimum values according to the preset measurement
values.
 Measurement values outside the set display range will be shown as maximum or minimum values.
o Click the Left Arrow to return to DETAILS view.
Figure 31. Y-Axis setup: Autoscale, ...and Manual setting
• Click the Right Arrow to return to SIMPLE view.
• Click Menu to return to the MAIN MENU screen.