Endress+Hauser Proline Prowirl 72 - 5.4 Operating programs

Proline Prowirl 72 FOUNDATION Fieldbus 5 Operation
Endress + Hauser 33
5. 4 Operating programs
5.4.1 Operating program "FieldCare"
Modular software package consisting of the "FieldCare" service program for the configuration and
diagnosis of ToF level measuring devices (time-of-flight measurement) and pressure measuring
instruments (Evolution series) as well as the "FieldCare" service program for the configuration and
diagnosis of Proline flowmeters. The Proline flowmeters are accessed via a service interface or the
FXA 193 service interface.
Contents of the "FieldCare":
• Commissioning, maintenance analysis
• Measuring device configuration
• Service functions
• Visualization of process data
• Troubleshooting
• Reading out the verification data and updating the software of the "Fieldcheck" flow simulator
5.4.2 Operation via FOUNDATION Fieldbus configuration programs
You can obtain special configuration and operating programs from various manufacturers for the
configuration. These can be used for configuring both the FOUNDATION Fieldbus functions and all
of the device-specific parameters. The predefined function blocks allow uniform access to all the
network and fieldbus device data.
A detailed step-by-step description of the procedure for commissioning the FOUNDATION Fieldbus
functions is given on Page 36 ff. together with information on configuring device-specific
parameters. For general information on the FOUNDATION Fieldbus, please refer to Operating
Instructions "FOUNDATION Fieldbus Overview" (BA013S). Available at:  www.endress.com 
Download.
System files
You require the following files for commissioning and configuring the network:
• Commissioning DD (Device Description: *.sym, *.ffo)
• Network configuration CFF file (Common File Format: *.cff)
These files can be acquired as follows:
• Free of charge via the internet www.endress.com
• From Endress+Hauser by quoting the order number (No. 50097199)
• From the Fieldbus Foundation Organization www.fieldbus.org
!
Note!
Make sure you are using the correct system files for integrating field devices into the host system.
Relevant version information can be queried with Prowirl 72 by means of the following parameters
in the Resource Block:
FOUNDATION Fieldbus interface:
• Resource Block  DEV_REV parameter
• Resource Block  DD_REV parameter
Example:
Display in the DEV_REV parameter  01
Display in DD_REV parameter  01
Device description file (DD) required  0101.sym / 0101.ffo