11 Operation via FOUNDATION Fieldbus Proline Prowirl 72 FOUNDATION Fieldbus
84 Endress + Hauser
11. 3 Transducer Block
The Transducer Block of the Proline Prowirl 72 FOUNDATION Fieldbus contains all the measuring
and device-specific parameters of the flowmeter. All the settings directly connected with the
application/flow measurement are made here.
It forms the interface between sensor-specific measured value preprocessing and the function blocks
required for automation.
A Transducer Block allows you to influence the input and output variables of a function block. The
parameters of a Transducer Block include information on the sensor configuration, physical units,
calibration, damping, error messages, etc. as well as the device-specific parameters.
The device-specific parameters and functions of Proline Prowirl 72 FOUNDATION Fieldbus are
split into several Transducer Blocks, each covering different task areas.
A0003797-EN
Fig. 31: Structure and function of the individual Transducer Blocks
Transducer Block “Service”
Transducer Block “Display”
Transducer Block “Diagnosis”
Transducer Block “Totalizer”
Totalizer
S
Volume Flow
O/S
Calc. Mass Flow
Mode_BLK
Tot. - Assign
Totalizer ... - Mode
Totalizer ... - Reset
Auto
Corr. Volume Flow
O/S
Auto
Auto
Transducer Block “Flow”
Volume
Flow
Signals
Calc.
Mass Flow
Mode_BLK
Auto O/S
Off Value
On Value
Simulation -
Measurand
System Param. -
Positive Zero Return
Low Flow
Cut Off-Assign
Simulation - Measurand Value
Amplifier
Corr.
FlowVolume
AI Block
CH 2
CH 1
CH 3
CH 7
To Next Page
Loading...
