Endress+Hauser Proline Prowirl 72 - 11.8 Endress+Hauser parameters: Transducer Block Diagnosis

11 Operation via FOUNDATION Fieldbus Proline Prowirl 72 FOUNDATION Fieldbus
112 Endress + Hauser
11. 8 Endress+Hauser parameters:
Transducer Block "Diagnosis"
The following table shows all the Endress+Hauser-specific parameters of the Transducer Block
"Diagnosis". These can only be changed after entering an enabling code in the "Un-/Locking -
Access Code" parameter.
Transducer Block "Diagnosis" (Endress+Hauser parameters) / base index 800
Parameter Write access for
operating mode
(MODE_BLK)
Description
! Note!
The FOUNDATION Fieldbus parameters of this block are described on Page 87.
Diagnosis -
Actual System
Condition
Read only The current system status appears on the display.
Display:
"SYSTEM OK" or the fault/notice message with the highest priority.
! Note!
An exact error description as well as information on rectifying errors can be
found on Page 49 ff..
Diagnosis -
Previous System
Condition
Read only The last error message to occur appears on the display.
Un-/Locking -
Access Code
AUTO - OOS All data of the measuring system are protected against inadvertent change.
Programming of the manufacturer-specific parameters is disabled and the
settings cannot be changed until a code is entered in this function.
You can enable programming by entering the:
• Code 72 (factory setting)
• Personal code, see "Un-/Locking – Define Private Code" parameter
(Page 108) Transducer Block "Display"
User input:
Max. 4-digit number (0 to 9999)
! Note!
• If write protection is enabled, access to manufacturer-specific parameters
is denied even if the right code is entered. Write protection can be
enabled or disabled by means of DIP switches (Page 35).
• You can disable programming again by entering any number in this
function (other than the Access Code).
• The Endress+Hauser service organization can be of assistance if you
mislay your private code.
• Certain parameters can only be altered if a special Service Code is
entered. This Service Code is known to your Endress+Hauser service
organization. Please contact your Endress+Hauser service point if
anything needs clarification.
Un-/Locking -
Access Status
Read only Use this function to display the current status of the possibilities for
accessing the manufacturer-specific parameters of the device.
Display:
• LOCKED (parameters cannot be modified)
• ACCESS CUSTOMER (parameters can be modified)
• ACCESS SERVICE (parameters can be modified, access to service level)

