Endress+Hauser Proline Prowirl 72 - Accessories; Transmitter; Mounting kit for Prowirl 72 W; Mounting kit for sensor

8 Accessories Proline Prowirl 72 FOUNDATION Fieldbus
44 Endress + Hauser
8Accessories
Various accessories, which can be ordered separately from Endress+Hauser, are available for the
transmitter and the sensor. Your Endress+Hauser service organization can provide detailed
information on the order codes in question.
Accessory Description Order code
Transmitter
Prowirl 72
Transmitter for replacement or for stock. Use the order code to
define the following specifications:
– Approvals
– Degree of protection / version
–Cable entry
– Display / operation
–Software
– Outputs / inputs
72XXX
 XXXXX*****K
Mounting kit for 
Prowirl 72 W
Mounting kit for wafer version consisting of:
– Threaded studs
– Nuts incl. washers
– Flange seals
DKW
 **–****
Mounting kit for
sensor
Mounting kit for remote version, suitable for pipe and wall
mounting.
DK5WM
 B
Conversion kits Conversion kits
– Prowirl 72 to Prowirl 73
– Compact version to remote version (10 meters, 30 meters)
DK7UP  **
Flow conditioner To reduce the inlet run after interference in the flow. DK7ST  ***
Applicator Software for selecting and planning flowmeters. The Applicator can
be downloaded from the Internet or ordered on CD-ROM for
installation on a local PC.
Contact your Endress+Hauser representative for more information.
DKA80
 *
Memograph M
graphic display
recorder
The Memograph M graphic display recorder provides information
on all the relevant process variables. Measured values are recorded
correctly, limit values are monitored and measuring points
analyzed. The data are stored in the 256 MB internal memory and
also on a DSD card or USB stick.
Memograph M boasts a modular design, intuitive operation and a
comprehensive security concept.
The ReadWin
®
2000 PC software is part of the standard package
and is used for configuring, visualizing and archiving the data
captured.
The mathematics channels which are optionally available enable
continuous monitoring of specific power consumption, boiler
efficiency and other parameters which are important for efficient
energy management.
RSG40 - ************
FieldCare Modular software package consisting of the "FieldCare" service
program for the configuration and diagnosis of ToF level measuring
devices (time-of-flight measurement) and pressure measuring
instruments (Evolution series) as well as the "FieldCare" service
program for the configuration and diagnosis of Proline flowmeters.
The Proline flowmeters are accessed via a service interface or the
FXA193 service interface.
Contents of the "FieldCare":
– Commissioning, maintenance analysis
– Measuring device configuration
– Service functions
– Visualization of process data
– Troubleshooting
– Access to the verification data and updating the software of the
"Fieldcheck" flow simulator
Contact your Endress+Hauser representative for more information.
See the product page on the
Endress+Hauser website:
www.endress.com