Endress+Hauser Proline Prowirl 72 - 9.4 Spare parts

9 Troubleshooting Proline Prowirl 72 FOUNDATION Fieldbus
56 Endress + Hauser
9. 4 Spare parts
Section 9. 1 contains detailed troubleshooting instructions (Page 46).
The measuring device, moreover, provides additional support in the form of continuous self-
diagnosis and error messages.
Troubleshooting can entail replacing defective components with tested spare parts. The illustration
below shows the available scope of spare parts.
!
Note!
You can order spare parts directly from your Endress+Hauser service organization by quoting the
serial number printed on the transmitter nameplate (Page 7).
Spare parts are shipped as sets comprising the following parts:
• Spare part
• Additional parts, small items (screws, etc.)
• Installation instructions
• Packaging
A0007372
Fig. 27: Spare parts for Proline Prowirl 72 FOUNDATION Fieldbus transmitter (field and wall-mount housing)
1 Fieldbus connector
2 Local display module
3Board holder
4 I/O board (COM module); Non-Ex, Ex i/IS and Ex n version
5 Amplifier board
6 I/O board (COM module); Ex-d/XP version
7Pre-amplifier
4
2
3
1
5
7
6