16-Channel Digital Video Recorder
3
Chapter 2 — Installation
Package Contents
The package contains the following:
y Digital Video Recorder
y Power Adaptor and Power Cord
y User’s Manual (This Document)
y RAS Software CD and User’s Manual
y Infrared Remote Control
Required Installation Tools
No special tools are required to install the DVR. Refer to the installation manuals for the other items that make up part
of your system.
Figure 2 — DVR rear panel.
Video Input Video Out Power Cord Connector
RS232 Port
RS485 Port
Alarm Input/Output
Network Port
Factory Reset Switch
Factory Reset Switch
Your DVR can be used with either NTSC or PAL equipment.
NOTE: You cannot mix NTSC and PAL equipment. For example you cannot use a PAL camera and an NTSC
monitor.
Video Input
Connect the coaxial cables from the video sources to the BNC Video In connectors.
To Next Page
