User’s Manual
72
Error Code Notices
System Upgrade Related Clip Copy Related
No. Description No. Description
0
Unknown error.
0
Unknown error.
1
File version error.
1
Device error.
2
Operating system version error.
2
Mounting failed.
3
Software version error.
3
No media.
4
Kernel version error.
4
Invalid media.
100
Upgrade device mounting failed.
5
File already existed.
101
Package is not found.
6
Not enough space.
102
Extracting package failed.
7
Creating temporary file failed.
103
LILO failed.
8
Opening disk failed.
104
Rebooting failed.
9
Formatting disk failed.
105
Invalid package.
10
Database has been changed.
300
Remote connection failed.
11
Appending failed.
301
Remote network error.
12
Bad sector.
302
Remote upgrade is not authorized.
13
No executable file.
303
Saving remote package failed.
14
Opening executable file failed.
304
Remote upgrade is cancelled by the user.
15
Writing executable file failed.
400
USB device mounting failed.
16
Creating image failed.
401
Reading upgrade package on the USB device
failed.
19
Connecting device failed.
402
Copying upgrade package on the USB device
failed.
20
Device is busy.
403
USB device is not connected.
21
Unsupported file system.
404
USB device is being used.
405
Unsupported file system.
500
System is busy clip copying.
Troubleshooting
Problem Possible Solution
No Power
y Check power cord connections.
y Confirm that there is power at the outlet.
No Live Video
y Check camera video cable and connections.
y Check monitor video cable and connections.
y Confirm that the camera has power.
y Check camera lens settings.
DVR has stopped recording
If hard disk drive is full, you will either need to delete video or set the DVR to the
Overwrite Mode.
The icon displays,
however, the DVR is not
recording.
When the DVR is in the Pre-Event recording mode, the yellow
and
display when
there is no event, and the DVR is not recording. The red
and
display when any
event occurs and the DVR starts recording.
To Next Page
Loading...
