16-Channel Digital Video Recorder
55
NOTE:
It is possible that no recorded image displays on the current screen. Press the
DISPLAY button and change
the screen mode to 4x4. You will be able to easily see the camera have recorded video during target time.
You can also narrow your event search by selecting the Option… button and setting up the new search condition.
You can search video from the first to last recorded images,
or you can set the start and stop times and dates.
Highlight the box beside From and press the
button to
toggle between On and Off. When set to Off, you can enter
a specific Date and Time. When set to On, the search will be
from the first recorded image.
Highlight the box beside To and press the
button to
toggle between On and Off. When set to Off, you can enter
a specific Date and Time. When set to On, the search will be
from the last recorded image
.
Highlight the box beside Check Time Overlap and press the
button. It toggles between On and Off. You will
only be able to turn the Check Time Overlap on or off if a user-defined date and time is set to From and To. If the DVR’s
date and time have been reset, it is possible for the DVR to have more than one overlapping start and stop time. When
set to On, you will be asked to select one of the overlapping start and stop time. When set to Off, the DVR will display
search results from all start times to all stop times.
Highlight the box beside Alarm-In and press the
button. You can select the alarm inputs that you want to include
in your search.
Highlight the box beside Motion and press the
button. You can select the cameras for which you want any reports
of motion detection.
Highlight the box beside Video Loss and press the
button. You can select the cameras for which you want any
reports of lost video.
Highlight the box beside Video Blind and press the
button. You can select the cameras for which you want any
reports of blind video.
Highlight the box beside Text-In and press the
button. You can select the text-in devices which you want any
reports of text input.
Highlight the box beside Record Channels and press the
button. You can select the cameras that you want to
search for any reports of event recorded data. The DVR will display the events (not the camera channels) that occurred
and that also are recorded on the camera channel that you selected. If you do not select a camera channel in this field,
the DVR will search events that are not associated with cameras.
You can also toggle On and Off self-diagnostic System Events as part of your search. The choices are:
y Panic Record
y Check Recording
y Check Alarm-In
y Disk Almost Full
y Disk Bad
y Disk Temperature
y Disk S.M.A.R.T.
y Fan Error
y Disk Config Change
Once you set your desired search conditions, highlight Search and press the
button to display the search results
in the Event Log Search screen. Selecting Cancel exits the screen without saving the changes.
To Next Page
Loading...
