76
WSG-1068 ENGINE
Camshaft - Removal
Special Tool(s)
Special Service Tools called for by the procedures can be
obtained by calling:
1-800-ROTUNDA (1-800-768-8632).
WARNING: DO NOT SMOKE OR CARRY
LIGHTED TOBACCO OR OPEN FLAME OF ANY
TYPE WHEN WORKING ON OR NEAR ANY FUEL-
RELATED COMPONENTS. HIGHLY FLAMMABLE
MIXTURES ARE ALWAYS PRESENT AND CAN BE
IGNITED, RESULTING IN POSSIBLE PERSONAL
INJURY.
1. Disconnect the battery ground cable (14301).
2. Remove the intake manifold (9424); refer to Intake
Manifold – Variable Resonance Induction System
(VRIS) in this section.
3. Remove the timing chains (6268); refer to Timing Drive
Components in this section.
CAUTION: The caps must be marked for
installation in their original location or damage
to the engine may occur.
4. Remove the six bolts retaining the balance shaft
bearing caps and remove the bearing caps.
5. Remove the balance shaft.
To Next Page
Loading...
