EN109-1665751-44
9.2.3 PAUSE button
The training can be paused temporarily (for example, to tie your shoelace or have a drink). You can do this by
pressing the PAUSE button [4] during the training session. A message (figure 9) will appear on the screen and
the band will gradually come to a standstill.
To resume the training, press the OK button [5]. A screen (figure 10) will appear, showing that the training is
being resumed. The pause screen will also show the selected running speed and incline.
Comment: if you press the STOP button once again while you are pause mode, the training session will
end permanently and the results screen will appear.
9.2.4 OK button (confirm button)
In order to confirm an action, for example continuing to the next screen or entering personal details, you must
press the OK button [5]. The information screen clearly states in text form which actions need confirming by
means of the OK button.
The OK button is also the button used to start a training session (with the exception of Quick start). Once you
have pressed the button, the band will start moving. The speed at which the band moves depends on the
selected function and selected (maximum) speed. In the case of Quick start, the speed must be selected
manually using the speed buttons [2].
Figure 11
9.2.5 STOP button
The treadmill can be stopped by pressing the STOP button [6] once. The band speed will gradually decrease
until it comes to a standstill. The training session will then come to a permanent end.
The Results screen showing the relevant parameters (such as distance covered, calories burned etc.) will then
appear. If desired, the results may be recorded on one of the score forms (see appendices 2 to 6). The details
can then be entered at a later date into an electronic patient record, for example.
To Next Page
Loading...