Enraf Nonius EN-Motion - Weight Loss (HRT)

37
EN109-1665751-44
Use of the chest strap
The Sigma heart-rate monitor system consists of a lightweight transmitter belt, worn round the chest, and a
receiver which is mounted in the control panel of the EN-Motion. By means of two electrodes, the transmitter
detects each heart beat and transmits it to the receiver. During the training session, the heart-rate value will
appear at the bottom of the information screen.
Fitting the chest strap:
The chest strap works best if the transmitter is worn next to bare skin. If you would prefer to wear the chest
strap over a top, you will also need to moisten the section of the top beneath the grooved areas.
A heart-rate monitor (Sigma belt) MUST be used with the following functions:
• Exercise goals ‘Condition improvement’ and ‘Weight loss’ (HRT programmes)
• Conconi test (exertion test).
With all other functions, a heart rate monitor (Sigma belt) MAY be connected if desired.
The Sigma belt allows the current heart rate to be shown during the training session.
10.4.4.a Weight loss (HRT)
First connect a heart-rate monitor (Sigma
chest strap).
Select the Exercise goals function from the
main menu using the central controller and
press OK.
Then enter the Personal details (gender, age,
height and weight) and press OK.
The list of Exercise goals will appear.
Select the Exercise goal Weight loss (HRT)
using the central controller and press OK.
1. Attach the transmitter to the elastic band.
2. The chest strap must fit comfortably and firmly around the chest.
3. Moisten the grooved rear surface of the transmitter, where the
electrodes are located.
4. Check whether the transmitter section is properly positioned, i.e.
straight and with the Sigma logo in the centre.