Select the Protocol lists function using the
central controller and press OK.
An option menu will appear.
Then select the Personal list using the
central controller and press OK.
First complete the Personal details screens
and press OK.
The list of saved personal protocols will
appear (P1 to P30).
Select the desired programme from the List
using the central controller and press OK.
The treadmill will now start automatically and
gradually accelerate until the desired
maximum speed has been reached *.
You can adjust the speed and inclination
using the + and – buttons (the inclination
can only be adjusted if the angle 0%).
After the training has been completed, an
audible signal will sound and the Results
screen will appear.
Note the results and record them on the results
form if desired (see appendix).
Press OK to return to the Main menu.
10.4 Exercise goals
This function allows you to offer your patient a range of targeted training options. You can choose from the
following Exercise goals:
1. Time (for example training to improve your performance in the Cooper test, a 12-min. endurance test)
2. Distance (for example a training session with the goal of increasing the distance covered)
3. Energy (training session goaled at ‘burning’ 300 Kcal, for example)
4. Weight loss (for example helping an obese patient to lose a few kilos)
5. Condition improvement (for example to improve the physical condition of a patient after a period of
immobilisation)
With Exercise goals 1, 2 and 3, a Sigma heart-rate belt may be connected in order to display the current heart
rate. If the heart rate exceeds 85% of the max. HR *, this is indicated by means of an audible and visual
signal. In this case, the speed and/or inclination must be reduced manually until the heart rate is below
the maximum value. For Exercise goals 4 and 5, a Sigma heart-rate belt must be connected.
To Next Page
Loading...