EN109-1665751-44
10.6.3 During the training session
Here, you will already have selected a training session from the main menu and entered the speed manually.
The band is therefore IN MOTION.
This means: first SELECT TRAINING SESSION AND ENTER SETTINGS, then manually START THE BAND
START and while you are walking or running ACTIVATE AUTOSPEED.
Step 1 SELECT TRAINING SESSION AND ENTER SETTINGS (Quick start example)
Select the desired function (for example Quick start) from the main menu and press OK.
The so-called data screen will appear (unless ‘Calories burned’ has been activated; in this case, first
enter the weight).
Step 2 START THE BAND
Start the band by pressing the + speed button. Press the button until the desired speed has been
reached and then release it.
Step 3 ACTIVATE AUTOSPEED
While you are walking or running press the AUTO button. If the function is secured, the access
code must first be entered (see 10.7.2). The indicator lamp will illuminate continuously and the
treadmill will immediately enter Autospeed mode. The user will be shown a (flashing) message on
the screen (‘Autospeed active’) for a few seconds. This message will disappear automatically after a
few seconds.
Please note: it is not possible to select a response profile! Speed changes will take place automatically in
accordance with the factory setting for the response profile (see 10.7.2).
10.6.4 Changing the Autospeed settings during the training session
During the training session, the following Autospeed settings can be changed:
1 the maximum Autospeed speed (the ‘speed limit’)
2 the response profile
3 the function can be activated and deactivated.
1 CHANGING THE MAX. AUTOSPEED SPEED DURING THE TRAINING SESSION
The maximum speed (‘speed limiter’) can be adjusted (increased or decreased) while walking or running
on the treadmill by manually pressing the speed buttons (+ button to increase the speed and – button to
decrease the maximum speed).
2 SELECTING A DIFFERENT RESPONSE PROFILE DURING THE TRAINING SESSION
For safety reasons, it is not possible to change the response profile while walking or running on the
treadmill. The band must first be brought to a standstill.
• To do so, press the PAUSE button. The pause screen will appear and the band will come to a
standstill.
• Then press the AUTO button. The indicator lamp will flash and the response profiles screen will
appear.
• Select a different profile and press OK to resume the training session.
• A screen showing the flashing text ‘START WALKING’ indicates that the training session will
resume with automatic speed adjustment (Autospeed). The band will start to move once again.
3 DEACTIVATING THE FUNCTION WHILE USING THE TREADMILL
• Press the AUTO button. The indicator lamp will go off.
• The current band speed will be retained and can be adjusted manually using the +/- speed buttons.
To Next Page
Loading...
Need help?
General