Epec 6107 - Gps;Glonass

Technical Manual &
Cabling Instructions
Page 35 / MAN000596
Interfaces
Epec Oy reserves all rights for improvements without prior notice
Epec Oy
Tiedekatu 6
FIN-60320 Seinäjoki
Postal address
PL/P.O.Box 194
FIN-60101 Seinäjoki,
Finland
Phone
+358-(0)20-7608 111
Fax
+358-(0)20-7608 110
Internet
www.epec.fi
12.7 GPS/GLONASS
This manual describes the full hardware version. Some of the features are
optional and not implemented in all hardware versions.
In addition to positioning, GPS can be utilized for example for fetching the UTC time for the
unit's real-time clock.
SMA connector in the unit:
SMA female
SMA connector type for cable:
SMA male *
SMA tightening torque:
brass: 0,3 - 0,6 Nm
steel: 0,8 - 1,1 Nm
Antenna:
It is recommended to use active antenna *
Internal power supply for active antenna:
2,85 V
Max current for active antenna:
10 mA
Ordering antenna:
See section Accessories and Ordering Codes
*
Related programming libraries:
GPS.library
(For more information, see Epec
Programming and Libraries manual)
*) Tested with Plantec Planar Combination Antenna K70ZVR (for using other antenna types,
additional testing is required)
Antenna connector location: