Epec 6107 - Wlan

Technical Manual &
Cabling Instructions
Page 36 / MAN000596
Interfaces
Epec Oy reserves all rights for improvements without prior notice
Epec Oy
Tiedekatu 6
FIN-60320 Seinäjoki
Postal address
PL/P.O.Box 194
FIN-60101 Seinäjoki,
Finland
Phone
+358-(0)20-7608 111
Fax
+358-(0)20-7608 110
Internet
www.epec.fi
12.8 WLAN
This manual describes the full hardware version. Some of the features are
optional and not implemented in all hardware versions.
A Firewall can be activated for the WLAN. For more information, refer to Epec
Programming and Libraries Manual > Programming > Programming 6000 Series
Units > Using Firewall (6000 Series).
Electrostatic-sensitive connector (WLAN SMA connector tested with +/- 2 kV
direct contact discharge)
Higher voltage levels may cause disturbance to the unit.
SMA connector type in device:
SMA female
SMA tightening torque:
brass: 0,3 - 0,6 Nm
steel: 0,8 - 1,1 Nm
Encryption
WPA
Standard Conformance
802.11 ac/a/b/g/n
Supported frequencies:
2,4 GHz
Ordering antenna:
See section Accessories and Ordering Codes
*
Related programming libraries:
WLAN.library
(For more information, see Epec
Programming and Libraries manual)
Tested with Plantec Planar WLAN Antenna M70XFR (Antenna Gain -3.0 dBi)
For using other antenna types, additional testing is required.