Epec 6107 - Mounting and Cleaning

Technical Manual &
Cabling Instructions
Page 54 / MAN000596
Mechanics and
Cabling
Epec Oy reserves all rights for improvements without prior notice
Epec Oy
Tiedekatu 6
FIN-60320 Seinäjoki
Postal address
PL/P.O.Box 194
FIN-60101 Seinäjoki,
Finland
Phone
+358-(0)20-7608 111
Fax
+358-(0)20-7608 110
Internet
www.epec.fi
15.2 Mounting and Cleaning
It is required that the unit housing has a galvanic connection to machine frame.
Control unit mounting location should be planned so that the machine's washing
does not damage the unit.
A direct water jet towards the control units should be avoided, especially when
using high pressure. Also, the use of any such solvent that causes damage to
electronic devices should be avoided when handling the control units.
When cleaning the control unit, do not use highly alkaline / acidic substances, too
hot water, or too heavy mechanical abrasion.
In moist conditions, the unit must be mounted and oriented so that the connectors
are not filled with water.
Make sure that all the unused connectors are sealed properly using the provided
covers (sealing cap protection class is IP67).
The display unit should be mounted to a location where it is protected from
impacts and
splashes. Usually the display unit is mounted in a machine cabin. However, if
display unit must
be mounted in such place that it is exposed to impacts or splashes, it should be
thoroughly
covered with a separate, mechanical cover. Platforms with extreme vibrations
should be
avoided.
The display unit can be mounted to the frame with a mounting pedestal or it can
be mounted on
a panel.