Technical Manual &
Cabling Instructions
Page 6 / MAN000596
Preface
Epec Oy reserves all rights for improvements without prior notice
Epec Oy
Tiedekatu 6
FIN-60320 Seinäjoki
Postal address
PL/P.O.Box 194
FIN-60101 Seinäjoki,
Finland
Phone
+358-(0)20-7608 111
Fax
+358-(0)20-7608 110
Internet
www.epec.fi
3.2 Basic Skills Required
The user of this document must have basic knowledge of machine controlling, CAN
communication, PLCopen programming according to IEC61131-3 and should have skills to use
CODESYS 3.5 programming environment.
Refer to CODESYS manual for further information concerning the programming environment
and required installations.
Refer to CAN and CANopen documentation from CAN in Automation (CiA) for further
information on communication issues.
3.3 Safety Guidelines
The user of this documentation should follow general machine safety guidelines, directives and
regulation appropriate to their country or market area.
A separate safety analysis is always recommended for the machine and its control system. The
features of this product should be well documented in machine and control system documents
so that the machine operator has the right information how to operate the machine correctly and
safely.
This product is designed to be used only for machine controlling purposes. The manufacturer
does not assume any responsibility for this product being fit for any particular application, unless
otherwise expressly stated in writing by the manufacturer.
This product complies with those certifications and standards that are mentioned in this manual.
The manufacturer does not guarantee that this product complies with any other certification,
standard or test other than mentioned in this manual.
This product is not field serviceable, so it should not be opened in any situation.
External fuses should be installed for the product or the system power supply.
The system should be designed and constructed according to the Epec general mounting and
cabling instruction document.
Epec Oy reserves a right to improve its products without a further notice.
3.4 Warranty
The surface of the touch screen is made of glass. Do not tap the touch screen
with sharp objects such as a screwdriver. The warranty does not cover any
damages caused by customers due to incorrect handling.
Information concerning the warranty of this product can be found from Epec General Sales and
Warranty Terms.
For more information, contact sales@epec.fi
To Next Page
Loading...