Epec 6107 - Page 66

Technical Manual &
Cabling Instructions
Page 66 / MAN000596
Mechanics and
Cabling
Epec Oy reserves all rights for improvements without prior notice
Epec Oy
Tiedekatu 6
FIN-60320 Seinäjoki
Postal address
PL/P.O.Box 194
FIN-60101 Seinäjoki,
Finland
Phone
+358-(0)20-7608 111
Fax
+358-(0)20-7608 110
Internet
www.epec.fi
15.4.2.1.1 CAN cabling for system developers
The following figure describes cabling for CAN communication between Epec control units and
a PC. Ordering codes for the needed hardware are included in the figure.
An external termination resistor (120 Ω) has to be connected at both ends
between CAN H and CAN L.