EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Overview 117
4.1.2 Tools to Be Used
The following table indicates the tools recommended for use for disassembly,
reassembly and adjustment.
NOTE:
#:Available
C A U T I O N
" When the printer model uses the HAV ink cartridges, transport
it after removing the ink cartridges. Especially for air
transportation, always remove the ink cartridges before
transportation since ink will flow into the cap via the head with
the reduction of the atmospheric pressure, causing ink leakage.
" Use only the recommended tools for disassembly, reassembly and
adjustment. (Refer to Table 4-1"Tool List".)
" Tighten screws to the specified torques.
" Use the specified lubricants and adhesives.
(Refer to Chapter 6 "Maintenance".)
" Make the necessary adjustments under the instructions given for
disassembling.
(Refer to Chapter 5 "Adjustment".)
" When reassembling the waste ink pads and tray, always make
sure that the waste ink tube is fitted correctly in the specified
place. Fitting the ink tube in other than the specified position can
cause ink leakage.
Figure 4-1. Position Specified for Ink Tube
Ink tube
Waste ink pad
Table 4-1. Tool List
Tool Name Supplier Code
Scale PF unit applying jig EPSON 1051767
Mounting plate scale jig EPSON 1051765
Phillips Screw Driver (No.1) # B743800400
Phillips Screw Driver (No.2) # B743800200
Tweezers # B741000100
PG adjustment gauge set EPSON 1113311
Nippers # B7405001
To Next Page
Loading...
