EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 127
4.2.2 Removing the Board Assembly
4.2.2.1 Removing the Panel Board
1. Remove the Upper Housing. (Refer to 4.2.1.1.)
2. Remove the three screws 5) C.B.P 3
×10 (6±1kgf.cm) that secure the Grounding
Plate and Panel Board, and remove the Grounding Plate and Panel Board from the
Upper Housing.
Figure 4-13. Screws That Secure the Grounding Plate and Panel Board
4.2.2.2 Removing the Board Unit
1. Remove the Rear Housing. (Refer to 4.2.1.2.)
2. Remove the five screws 6) C.B.S 3
×6 (9±1kgf.cm) and one screw 2) C.B.S 3×10
(9±1kgf.cm) that secure the Board Unit, slightly pull the Board Unit to the front as
viewed from the printer rear, and disengage the Ferrite Cores located on the Lower
Frame and Board Unit side using a flat-blade screwdriver.
Figure 4-14. Screws That Secure the Board Unit
Grounding Plate
C.B.P 3×10
C.B.P 3×10
Panel Board
1
3
5 2
4
C.B.S 3×6
Board Unit
C.B.S 3×10
Rear right side
Ferrite Cores
To Next Page
Loading...
