EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 131
4.2.3 Removing the Waste Ink Pads
1. Remove the Lower Housing. (Refer to 4.2.1.4.)
2. Peel the Waste Ink Pad Fixing Films, which secure the Waste Ink Pads, from the
Lower Housing, and pull up and remove the Waste Ink Pads from the Lower
Housing.
Figure 4-21. Removing the Waste Ink Pads
A D J U S T M E N T
R E Q U I R E D
" When changing the PSB/PSE Board, make the following
adjustment.
• CR Motor drive torque dispersion measurement
" Refer to "Chapter 5 Adjustment" for the adjustment
procedure.
Waste Ink Pad Fixing Films
Waste Ink Pad Fixing Films
Waste Ink Pads
Waste Ink Pads
Waste Ink Pad
Waste Ink Pad (Small)
Waste Ink Pad (Small)
To Next Page
Loading...
