EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 186
4.2.19 Fitting the Protective Materials
This section describes how to fit the protective materials that are needed when
returning the printer to the user.
1. Fit a protective material between the I/C Cover and Carriage Unit, and apply a
blue tape from the Carriage Unit to the I/C Cover and to the right side (as seen
from the printer front) of the Upper Housing to fix the Carriage Unit.
Figure 4-147. Fixing the Carriage Unit
2. Insert protective materials into the first and third stages of the Stacker and also
insert a protective material into between the Stacker and Middle Housing.
Figure 4-148. Fixing the Stacker
3. Apply blue tapes to two areas of the Upper Housing and Stacker to fix them.
Figure 4-149. Fixing the Upper Housing and Stacker
4. Apply blue tapes to the left and right of the Rear Housing and Middle Housing to
fix them.
Figure 4-150. Fixing the Rear Housing and Middle Housing
Blue tape
Protective
materials
Protective material
Blue tapes
Blue tape
To Next Page
Loading...
