EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 120
4.2 Disassembly
! Follow the flowchart shown below to proceed with disassembling procedures. When disassembling any unit, refer to the page number shown in the following flowchart.
Figure 4-2. Disassembling Procedure Flowchart
Removing the Upper
Housing
4.2.1.1 Page121
START
Removing the Middle
Housing
4.2.1.3 Page124
Removing the Board
Unit
4.2.2.1 Page127
Removing the Rear
Housing
4.2.1.2 Page123
Removing the
Printhead
4.2.7 Page146
Removing the Lower
Housing
4.2.1.4 Page125
Removing the Printer
Mechanism
4.2.1.4 Page125
Removing the Waste
Ink Pads
4.2.3 Page131
Removing the Paper
Eject Unit
4.2.5 Page140
Removing the Paper
Eject Roller B
4.2.6 Page144
Removing the PF
Roller
4.2.15 Page175
Removing the Paper
Eject Roller Shaft A
4.2.16 Page179
Removing the Carriage
Guide Shaft B
4.2.8 Page149
Removing the Carriage
Guide Shaft A and
Carriage Unit
4.2.9 Page152
Removing the PW
Sensor
4.2.12.5 Page164
Removing the PF
Roller Support
4.2.17 Page181
Removing the ASF
Unit
4.2.4 Page132
Removing the CR
Motor
4.2.13.1 Page168
Removing the Rear
Housing
4.2.1.2 Page123
Removing the Board
Unit
4.2.2.2 Page127
Removing the Main
Board
4.2.2.3 Page129
Removing the PG
Sensor and Release
Sensor
4.2.12.1 Page161
Removing
the PSE/PSB Board
4.2.2.4 Page130
Removing the ASF
Unit
4.2.4 Page132
Removing the ASF
Sensor
4.2.12.2 Page162
Removing the Middle
Housing
4.2.1.3 Page124
Removing the PF
Encoder Sensor
4.2.12.3 Page162
Removing the
Printhead
4.2.7 Page146
Removing the Ink
System Unit
4.2.10 Page158
Removing the CR
Encoder Sensor Board
4.2.12.6 Page165
Removing the Ink
System Unit
4.2.10 Page158
Removing the PE
Sensor
4.2.12.7 Page166
Removing the DE Unit
and ASF/Pump Motor
4.2.14 Page171
Removing the DE Unit
and ASF/Pump Motor
4.2.14 Page171
Removing the ASF
Unit
4.2.4 Page132
Removing the Release
Lever Shaft
4.2.11 Page159
Removing the CD-R
Sensor
4.2.12.4 Page163
Removing the PF
Motor
4.2.13.2 Page170
* The step for the unit or discrete part within the broken line is not the
shortest removal step but is the step necessary for removing the next
unit or discrete part.
To Next Page
Loading...
