Epson 2200 - Stylus Photo Color Inkjet Printer - Panel Operation for CD-R Printing; Panel Operation for Thick Paper Printing

EPSON Stylus PHOTO 2100/2200 Revision B
PRODUCTION DESCRIPTION Functions 33
1.3.9 Panel Operation for CD-R Printing
The following indicates the basic panel operating procedure for printing on CD-R.
*a : If power is switched off and then on again at this point, the CD-R tray is not
ejected and a paper jam error occurs. When you further press the Paper
switch, the CD-R tray is ejected to the front and the printer returns to the
normal mode.
*b : If power is switched off and then on again at this point, the CD-R tray is
ejected to the front and the printer returns to the normal mode.
1.3.10 Panel Operation for Thick Paper Printing
The following indicates the basic panel operating procedure for printing on thick paper.
*a : If power is switched off and then on again at this point, the thick paper is not
ejected and a paper jam error occurs. When you further press the Paper
switch, the thick paper is ejected and the printer then returns to the normal
mode.
*b : If power is switched off and then on again at this point, the thick paper is
ejected and the printer returns to the normal mode.
Operating procedure
1. Move the Release lever to the
farthest position.
The Paper LED blinks fast.
If the print data has already been
sent, print operation is stopped
temporarily.
2. Along the paper feed guide, put the
CD-R tray folder into the printer
front and push the CD-R tray into
the specified position toward the
printer rear.
3. Return the Release lever to the
original position.
The Paper LED stops blinking fast.
4. Press the Paper switch.
The CD-R tray is fed
automatically. If it is not fed
properly, the CD-R tray is ejected
to the front and a paper feed error
occurs.
5. Send the print data.
After printing is over, the CD-R
tray is ejected.
*
a
*
a
*
b
Operating procedure
1. Move the Release lever to the
farthest position.
The Paper LED blinks fast.
If the print data has already been
sent, print operation is stopped
temporarily.
2. Along the paper feed guide, insert
the thick paper into the printer rear.
3. Return the Release lever to the
original position.
Insert the thick paper along the
right end of the paper feed guide.
The Paper LED stops blinking fast.
4. Press the Paper switch.
The thick paper is fed
automatically. If it is not fed
properly, a paper feed error occurs,
or if the CR interferes with the
thick paper, a paper thickness error
occurs.
5. Send the print data.
After printing is over, the thick
paper is ejected.
*
a
*
b