EPSON Stylus PHOTO 2100/2200 Revision B
PRODUCTION DESCRIPTION Functions 32
PANEL OPERATION IN ROLL PAPER MODE (WITH CUTTER)
To shift to the paper roll mode, use the roll paper mode selection command of the
remote commands.
Specify the cutting position of the roll paper using the cutting position specifying
command of the remote commands. When the specified position comes to the cutting
position, the paper is cut automatically.
If the cutting position specifying command is not available for the roll paper, perform
the "Panel operation in roll paper mode (Without cutter, tear-off line printing)" on Page
31.
*a : If power is switched off at this point, the panel feeding status is stored onto
the EEPROM. When power is switched on again, the printer does not eject
paper. The operation in Step 2. and later can be performed.
*b : If power is switched off at this point, Tear Off is executed automatically to cut
the roll paper, and the roll paper mode status is stored onto the EEPROM.
When power is switched on again, the printer does not eject paper. The
operation in Step 3. and later can be performed.
*c : If power is switched off at this point, the roll paper mode status is stored onto
the EEPROM. When power is switched on again, the printer does not eject
paper. The operation in Step 3. and later can be performed.
*d : If power is switched off at this point, the roll paper mode is canceled and the
panel feeding cancel is stored. When power is switched on again next, the
printer enters the normal mode if the Paper detection sensor is off.
1. Insert roll paper from the roll paper
guide.
With the Paper detection sensor on
for 2 seconds, the roll paper is fed
automatically. After the roll paper
is fed, the operation with the Paper
switch is masked.
*
a
2. Receive the roll paper data and
perform printing until the end of the
job. If the cutting specified position
reaches the cutter blade position
during printing, the roll paper is cut.
If consecutive print jobs come, the
CR stops at the end of the last job
and the printer does not eject nor
cut the paper and enters the switch
waiting status. At this time, there
are no print margins between the
jobs.
3. Press the Roll paper switch to
execute Tear Off cutting. Return
from Tear Off is then performed
automatically.
If there is a next print jog, the
printer prints and Steps 2. and 3.
are repeated.
Continued to the right
field.
*
b
*
c
Operating procedure
4. Press the Roll paper switch for 3
seconds to back out the paper.
Continued from the left field
After back-out, the Paper LED
blinks. The masked Paper switch is
de-masked. If the roll paper cannot
be removed after one back-out,
press the Roll paper switch or
Paper switch for 3 seconds to
execute back-out again.
5. When the roll paper cannot back out
any more, remove the roll paper
with your hands.
6. Press the Roll paper switch or Paper
switch to clear a paper jam. The
printer returns to the normal mode.
The Paper LED goes off.
*
d
*
d
To Next Page
Loading...
