Epson 2200 - Stylus Photo Color Inkjet Printer - Page 82

EPSON Stylus PHOTO 2100/2200 Revision B
TROUBLESHOOTING Troubleshooting 82
Table 3-4. Phenomenon-Based Release Lever Error Check Points
Occurrence Timing Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
At power-on At power-on, the Paper guide of
the Printer mechanism is open
and Release lever error is
displayed.
Release lever 1. Check that the Release lever is not in the far position, or when the
CD-R tray is not fitted (Only for Stylus PHOTO 2100), is not in
the CD-R printing position.
2. Check that the Release lever is not in other than the CD-R
printing position when the CD-R tray is fitted.
(Only for Stylus PHOTO 2100)
1. Move the Release lever to the front or thick
paper printing position.
2. Move the Release lever to the CD-R printing
position.
(Only for Stylus PHOTO 2100)
The Release lever is in the front
position and the Paper guide is
closed but Release lever error is
displayed.
Release lever
sensor
1. Check that the Release lever sensor connector cable is connected
to the Release lever sensor and Main board (CN1) securely.
2. Move the Release lever sensor detection lever manually in the
same state as when the Release lever makes contact with the
Detection lever, and check that the Detection lever returns to the
original position automatically when released.
3. Using a tester, check that the Release lever sensor is normal.
• Connector (CN1)
Open : 3.3V
Not open : 0V
1. Connect the Release lever sensor connector
cable to the Release lever sensor and Main
board (CN1) securely.
2. Change the Release lever sensor for a new one.
3. Change the Release lever sensor for a new one.
Release lever sensor