Epson EB-440W User Manual

When the mail notification function is set to On and the projector enters
an error or warning state, the following mail will be sent.
Subject: EPSON Projector
Line 1: The name of the projector where the problem occurred
Line 2: The IP Address set for the projector where the problem has
occurred.
Line 3 and on: Details of the problem
The details of the problem are listed line by line. The following table shows
the details that are given in the message for each item. To deal with
problems/warnings, see "Reading the Indicators".
s p.94
Message Cause
Internal error Internal Error
Fan related error Fan Error
Sensor error Sensor Error
Lamp timer failure Lamp Failure
Lamp out Lamp Error
Internal temperature error High Temp Error
(Overheating)
High-speed cooling in progress High Temp Warning
Lamp replacement notification Replace Lamp
No-signal No Signal
No Signal is input to the projector. Check
the connection status or check that the
power for the signal source is turned on.
Auto Iris Error Auto Iris Error
Power Err. (Ballast) Power Err. (Ballast)
A (+) or (-) appears at the start of the message.
(+): A projector problem has occurred
(-): A projector problem has been dealt with
Reading Error Notification Mail
107

Epson EB-440W Specifications

General

Projection technology	LCD
Contrast ratio (typical)	1600:1
Projector native resolution	WXGA (1280x800)
Aspect ratio	16:10
RS-232 ports	1
Dimensions (WxDxH)	369 x 481 x 115 mm
Lamp type	UHE
Lamp power	230 W
Light source type	Lamp
Service life of light source	2500 h
Service life of light source (economic mode)	3500 h
RMS rated power	10 W
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power consumption (standby)	1 W

Weight and Dimensions

Weight	5700 g