Epson EB-440W User Manual

Wired LAN menu
Sub-menu Function
IP Settings
You can make settings related to the following addresses.
DHCP g : Select whether or not (On/Off) to use DHCP. If this is set to On, you cannot set any more addresses.
IP Address g : You can input the IP address assigned to the projector. You can input a number from 0 to 255 in each field of the address. However, the
following IP addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Subnet Mask g : You can input the subnet mask for the projector. You can input a number from 0 to 255 in each field of the address. However, the
following Subnet Masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address g : You can input the IP address of the gateway for the projector. You can input a number from 0 to 255 in each field of the address.
However, the following gateway addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
IP Address Display
To prevent the IP address from being displayed on Network Info in the Network Menu and on the LAN Standby screen, set this to Off.
List of Functions
86

Epson EB-440W Specifications

General

Projection technology	LCD
Contrast ratio (typical)	1600:1
Projector native resolution	WXGA (1280x800)
Aspect ratio	16:10
RS-232 ports	1
Dimensions (WxDxH)	369 x 481 x 115 mm
Lamp type	UHE
Lamp power	230 W
Light source type	Lamp
Service life of light source	2500 h
Service life of light source (economic mode)	3500 h
RMS rated power	10 W
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power consumption (standby)	1 W

Weight and Dimensions

Weight	5700 g