When WEP is selected
You can set the following items.
Sub-menu Function
WEP encryption
You can set the encryption method for WEP encryption.
128bit: Uses 128 (104) bit encoding
64bit: Uses 64 (40) bit encoding
Format
You can set the input method for the WEP encryption key.
ASCII: Input in text.
HEX: Input in HEX (hexadecimal).
Key ID
You can select the WEP encryption ID key.
Encryption key 1
Encryption key 2
Encryption key 3
Encryption key 4
You can enter the key used for WEP encryption. Enter the key in single-byte characters following instructions from the network administrator for the
network in which the projector participates. The type of character and the number that can be entered differ according to the WEP encryption and
Format settings.
If the number of characters you enter is shorter than the required character length, or if the number of characters you enter is longer than the required
character length, it does not connect.
128bit - ASCII: Single-byte alphanumeric characters, 13 characters.
64bit - ASCII: Single-byte alphanumeric characters, 5 characters.
128bit - HEX: 0 to 9 and A to F, 26 characters
64bit - HEX: 0 to 9 and A to F, 10 characters
Authentication Type
Set the WEP authentication type.
Open: Uses open system authentication.
Shared: Uses shared key authentication.
When WPA-PSK (TKIP) or WPA2-PSK (AES) is selected
You can set the following items.
Sub-menu Function
PSK
You can enter a PreSharedKey (encrypted key) in single-byte alphanumeric characters. Enter at least 8 and up to 63 characters. When the PreSharedKey
is entered and the [Enter] button is pressed, the value is set and displayed as an asterisk (*).
You cannot enter more than 32 characters in the Configuration Menu. If you want to set more than 32 characters, make the setting from Web Control.
s p.64
List of Functions
85
To Next Page
Loading...
Need help?
General
Weight and Dimensions
