Epson EB-440W User Manual

Others Menu
Sub-menu Function
SNMP
Set whether or not (On/Off) to use SNMP.
Trap IP Address 1
Trap IP Address 2
You can register up to two IP addresses for the
SNMP g trap notification destination.
You can input a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer.SNMP should be managed by a network
administrator.
Priority gateway
For the priority gateway, select either wireless or wired.
AMX Device Discovery g
When the projector is connected to a network, set this to On to allow the projector to be detected by AMX Device Discovery. Set this to Off if you are not
connected to an environment controlled with a controller from AMX or AMX Device Discovery.
List of Functions
88

Epson EB-440W Specifications

General

Projection technology	LCD
Contrast ratio (typical)	1600:1
Projector native resolution	WXGA (1280x800)
Aspect ratio	16:10
RS-232 ports	1
Dimensions (WxDxH)	369 x 481 x 115 mm
Lamp type	UHE
Lamp power	230 W
Light source type	Lamp
Service life of light source	2500 h
Service life of light source (economic mode)	3500 h
RMS rated power	10 W
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power consumption (standby)	1 W

Weight and Dimensions

Weight	5700 g