Setting the Projector
126
c
While holding down the [Menu] button on the remote control or the control panel, connect
the power cord to the projector
The Power indicator and the Status indicator turn blue, and the Laser indicator and the Temp indicator
turn orange.
When all of the projector's indicators turn on, release the [Menu] button.
The projector is recognized as a removable disk by the computer.
d
Copy the batch setup file (PJCONFDATA.bin) that you saved to your computer to the top-
level folder of the removable disk
c
Do not copy any files or folders other than the batch setup file to the removable disk.
e
Perform "Remove USB device" on your computer, and then disconnect the USB cable
c
When using a Mac, perform "Remove EPSON_PJ".
When all of the indicators start flashing, the settings are being written.
Caution
Do not disconnect the power cord from the projector while the settings are being written. If the
power cord is disconnected, the projector may not start correctly.
When writing completes normally, the projector turns off, and only the Power indicator is lit blue.
To Next Page
Loading...
Need help?
General
