Setting the Projector
127
When Setup Fails
Check Remedy
Are the Laser and the Temp indicators
flashing orange quickly?
The batch setup file may be corrupt, or the USB flash drive or USB
cable may not be connected correctly. Disconnect the USB flash
drive or the USB cable, unplug and then plug in the projector's
power cord, and then try again.
Are the Power and the Status indicators
blue, and the Laser and the Temp indica‐
tors flashing orange quickly?
Writing the settings may have failed and an error may have occurred
in the projector's firmware. Stop using the projector, remove the
power plug from the electrical outlet, and contact Epson for help.
To Next Page
Loading...
Need help?
General
