Adjusting the Interactive Pen
86
Calibrating the Interactive Pen
Adjust the projector’s image before calibrating the pen.
There are two methods available for calibrating the pen; Auto Calibration and Manual Calibration.
When calibrating the pen for the first time, perform Manual Calibration for optimum calibration.
When calibrating the pen for the second time and after, perform Auto Calibration. ( p.88)
c
When the Screen Type is set to 16:6, replace the soft pen tip with a hard pen tip.
Manual Calibration
a
Turn on the projector, and then press the [Menu] button
Using the Remote Control Using the Control Panel
b
Select Manual Calibration from the Pen/Touch menu.
c
When multiple projectors are installed in parallel, you see a message prompting you to
temporarily hide the image for the projector installed next to it. When you see this message,
press the [A/V Mute] button to hide the image from the next projector.
To Next Page
Loading...
Need help?
General
