Installing the Touch Unit
92
Touch Unit installation location
The procedure differs depending on where the Touch Unit is installed.
When installed on the projection surface: Secure
with magnets or screws
When installed on a different surface: Secure with the
Touch Unit Bracket
Caution
When using the Touch Unit, images should be projected onto the front of the screen. You
cannot use finger touch operations when images are projected onto the rear of the screen.
Before installing the Touch Unit, make sure that the installation surface is not warped or
distorted, and that any unevenness on the screen surface is less than 5 mm.
To Next Page
Loading...
Need help?
General
