Using the Remote Control Panel Utility (EPL-6200 only) 245
7
7
7
7
7
7
7
7
7
7
7
7
Operating environment
Installing the Remote Control Panel utility
Follow these steps to install the Remote Control Panel utility:
1. Insert the printer software CD-ROM into your computer’s
CD-ROM drive.
2. Type the following at the DOS prompt, and then press the
Enter key.
D:\RCP\SETUP
Note:
The drive letter varies, depending on your computer.
3. Follow the on-screen instructions.
Operating system: MS-DOS Version 3.3x or later. The mouse
can be used, provided that the mouse driver
is installed. (Microsoft Mouse v.7.04 or
better, or Logitech v.6.43 or better.)
Memory: 360 KB minimum, although the actual
requirement varies depending on the
version of the operating system.
Interface: Parallel. The utility works in both
bidirectional and unidirectional parallel
interface modes. In unidirectional mode, the
computer can transmit settings to the printer
but cannot retrieve settings data from the
printer.
To Next Page
Loading...
